GE WD24X10014 Drain Hose for Dishwasher

GE WD24X10014 Drain Hose for Dishwasher

OE Part, design not great, but functions fine.
The end of the hose that matches up to your disposer is a "universal" fit, which means it may or may not seal as well as expected. In our case, the outlet of our In-Sink-erator was formed for a threaded hose attachment, which this does not have. It was a matter of smashing the hose on as far as it would go and tightening the clamp as much as possible. Think it is more of a design shortcoming than a fault of the product itselt.

Good news was that after a couple of cycles, it seemed to clear up the problem with too much water sitting in the bottom of the dishwasher.





- 77" NON-KINKING DRAIN HOSE WITH 5/8" I.D. INLET - SINK-END OUTLET IS EXPANDED TO FIT DISPOSER OR CUT OFF FOR SINK TEE SEE ALSO: WD24X10003 1/2" I.D. INLET

• WD24X10014
• 77-Inch non-kinking drain hose with 5/8-Inch ID inlet
• Genuine GE factory part